Peugeot 308 Key Fob Replacement
Peugeot's 308 might be somewhat old-fashioned but it's striking. It's not the most luxurious car in its class, but it is a relaxing and civilised driving experience.
Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. The following tips will aid in solving the issue whether it is constant or intermittent.
Water Damage
If you accidentally drop your key fob in a puddle or it is wet while kayaking, canoeing, rafting, or canyoning, the fob is likely to be damaged by water. The best way to avoid this from happening is to always keep it in a dry container when you're going outdoors or doing activities that require the fob to be exposed to large amounts of water.
It is also important to make sure that the fob is dry before opening it up and re-using it. If you detect any smells emanating from the fob like an industrial liquid smell or that of windshield washer fluid, this is another indication that it's submerged in water.
A wet circuit board can cause the battery to lose its energy or even explode. If you're able, if you can, pull the 308 key fob of whatever body of water it was stuck in, flip the button side down and shake it out as much water as possible before opening the case. After you open it, take out the battery and clean the circuit board using the help of a cotton swab that has been dipped in 90 percent isopropyl alcohol.
Other reasons your Peugeot 308 remote keyless entry system may not function include a dead battery for your coin problems with the receiver module signal interference, an electronic chip malfunctioning. If none of the above are the issue you can restart the system by removing the 12 Volt battery from the vehicle for 15 minutes.
Dead Coin Battery
Peugeot cars come with a remote start system that allows the driver to start the car from a distance and then warm up or cool down the vehicle prior to getting in. This feature is extremely useful particularly during the winter's cold and chilly months. But sometimes, the remote stop system stops operating due to a range of reasons, such as the battery of a coin that is dead.
A coin-shaped battery that is found inside the key fob can last for a period of between two and four years, based on how frequently it is used and where it's purchased. The date of use is usually printed on the packaging or written in the manual.
If the key fob stopped functioning after exposure to water that is clean then you must remove the battery, clean the chip using a paper towel and isopropyl ethanol, then dry it completely before replacing it. If the key fob was exposed to soapy or salty water, it could have caused the chip to be damaged. It is necessary to replace it.
If you're not sure the battery is in good condition it is possible to test its voltage using a multimeter set to your vehicle's voltage range and connected to the plus and minus terminals. If the voltage is less than 12-13 volts, you should replace the battery. You can also attempt to reset the onboard computer by disconnecting the battery with 12 volts for a few minutes and reconnecting it in reverse order (positive cable first, then negative). peugeot 308 key replacement should start after this.
Faulty Receiver Module
If you're not getting the "Key Detected" message on your dashboard, then it's possible that the receiver module has been afflicted with a fault. It's the component that sends a signal to the car when the key fob is activated, it also acts as an immobiliser, and stops it from starting until the correct key is used.
This can be due to various reasons, such as water damage or simply getting old. If the electronic chip inside your Peugeot 308 keyfob has been damaged by dirty tap water it could be because the keyfob was exposed it. In this case you will have to take it off and thoroughly clean it with isopropyl or electronic cleaner. When the battery is clean, you can try again.
If the issue isn't resolved then it's a good idea to visit an area Peugeot specialist or locksmith. They can utilize a diagnostic tool in order to pinpoint the issue and repair it.
It can be a stressful experience to lose your Peugeot car key. A professional auto locksmith can solve the issue in a matter of minutes. They can program your car and cut a new functioning key for you. Click here to find a locksmith near you.
Faulty Electronic Chip
The electronic chip that is in the Peugeot 308 key fob is a very important component of the remote control system. If it becomes damaged, your car might not start or you may receive a message that reads "anti-theft active". If this happens, the only way to fix the issue is to obtain a new key. Auto locksmiths who are professionals are able to offer the service in the shortest time.
The chip inside your Peugeot 308's key fob may fail due to many reasons, including sweat, water damage, or dirt. If your Peugeot 308 key fob is exposed to soapy water, it is recommended to clean it immediately. You can make use of a towel and isopropyl alcohol to wipe the electronic component. The battery must then be allowed to fully dry.
Sometimes the key fob may stop working because of radio interference. This is usually caused by other devices operate on the same frequency as your Peugeot keyfob. It can also be caused by bad weather or objects in the vicinity. It is recommended to see a Peugeot dealer in the event of this issue.
The Peugeot 207/308 Key Fob is delicate and needs particular care. It is essential not to drop or throw the key fob. If you lose it, try to locate it as soon as you can. You can reset all the on-board computers by disconnecting the battery that is 12 volts for a few minutes. Make sure you disconnect the negative cable first before connecting the positive.